Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A focused how-to on installing quick-hitch bushings onto three-point implement pins. The video covers why bushings are needed, the difference between Class 1 and Class 2 sizes (same outer diameter, different inner bore), and the step-by-step installation: sliding the bushing on, finding the aligned hole set, noting the beveled drive end, and hammering in the roll pin. Best for first-timers who just bought a quick hitch and are puzzled by the loose fit.
Without bushings installed, the fit between the quick hitch and implement pins is loose and sloppy. Bushings are needed for every implement to get a tight, properly designed fit.
They have the same outside measurement since the quick hitch is one size, but Class 1 bushings have a smaller inside bore and Class 2 bushings have a bigger inside bore.
Slide the bushing over the pin with the thickest part facing out, find the offset hole set that lines up, then hammer the roll pin in, starting with the beveled side first.