Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Dave converts a pinned Bolens Iseki G294 bucket to a quick-attach system compatible with Bobcat attachments, doing the welding live with a new ArcCaptain ARC250 stick welder. The video splits its focus: half is a practical fabrication walkthrough (cutting old welds, fitting plates, trialing 6013 and 7018 rods), half is a welder first-look including an actual amp-meter test at max output. Best for DIY owners curious about budget quick-attach conversions or that specific welder.
Cut off the old welds section by section, square up and tack on new plates at 90 degrees, then weld on box assemblies with quick-attach locks on each side so attachments can be picked up and dropped.
Dave tested it with a DC amp meter rated to 400 amps and burned a rod at the max setting, confirming a reading of 250 amps.
Dave tried both 6013 and 7018 rods and found a 3/32 inch 7018 rod gave the best penetration and filled gaps well, calling it the winner.
Dave, who says he lacks arc welding experience, found the stop-start easy and smooth, noting it has a synergic mode that sets amps based on rod size.