Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Focuses on a specific real-world problem: can a 57-hp Category 1 tractor physically mount and run a Category 2 stump grinder (the Balite 3P38) rated for 70-100 hp machines? The video walks through unpacking, the pin and bushing conversion steps needed to mate Cat 2 to Cat 1, hydraulic hookup, and a first test spin, but explicitly defers actual stump-grinding results to follow-up videos. Best for owners facing the same Category mismatch.
The video sets out to test this with a 57-hp Category 1 tractor and a Cat 2 stump grinder rated for 70-100 hp, converting pins and bushings to make it fit, with results shown in follow-up videos.
Use Category One to Category 2 lift arm bushings, available for five dollars at Tractor Supply, slid over the threads, then cut down to match the steel plate thickness so the nut locks tightly without flexing.
The 1 means fixed, the 3 means it articulates in three directions. The 24 and 34 reference cutting wheel size, with bigger wheels needing more power and a bigger tractor.