Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Focuses on the practical challenge of re-configuring an IronCraft 2510 flex-wing mower when switching it to a new tractor (the T574), because drawbar height differences throw off the cut. Tony walks through diagnosing a dragging skid, adjusting the wing-leveling linkage, and connecting the PTO using a quick-link tool. Ends with a brief mow test confirming the fix. Best for owners already familiar with this mower who need guidance on tractor-swap setup.
If the drawbar is a little high or low compared to the old tractor, it affects the cut, causing a skid to drag and tear up the yard.
You adjust the linkage on that side, which controls how much pressure the wheel puts down, raising or lowering that side of the mower.
Put the travel locks in, running them from the piston top to bottom to lock the wings in place so they cannot lean out or fall during travel.