Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow, practical how-to: removing the front loader attachment from a Kubota BX2370 using its factory stand. It walks through pulling the keeper pins, lowering the stand, dropping the bucket to release the rear keepers, backing the tractor out of the cradle, and disconnecting/capping the four hydraulic lines. It's a quick procedural walkthrough, not a tractor review, best suited to BX2370 owners doing this task themselves.
Pull the stand keeper, lower the stand, lower the bucket to loosen rear keepers, pull the keepers, use the joystick to free the loader, back up, then disconnect and cap the four hydraulic lines.
After backing the tractor up about six inches, pull off all four hydraulic lines, clean them, and cap them.
Yes, lowering the front bucket down until it touches the ground loosens the keepers that hold the back end of the bucket in place.