Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step installation walkthrough for a $625 diverter-valve kit that adds rear remotes by tapping into an existing loader valve. The creator installs it on a New Holland T-1510, covering unboxing, dash-panel drilling, hose routing, plug-and-play versus economy wiring, breakaway clamp assembly, and a live demo showing how the diverter switches between loader and remote functions. Best for owners planning to install this specific kit themselves.
With the plunger in, the loader runs as normal. Push the plunger and the loader locks in place, so lever motion now controls the rear remote instead, while the dump circuit stays usable.
On the plug-and-play kit you just disconnect the loader connections and plug in the switching valve. On the economy kit you use a wrench to remove the quick connection and install it on the loader end.
Find the groove about a quarter inch from the end of the quick connect, set the bolt, lock washer, and nut, then tighten with a 7/16 socket and backup wrench until the clamp sides are fully tight.