Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a diagnostic walkthrough for a B7800 with a dead loader lift, framed around a neighbor's real breakdown. It covers a step-by-step troubleshooting order: checking shared hydraulic/transmission fluid level and condition, inspecting the hydraulic filter and suction line, checking the relief valve (around 2,400 PSI), and a specific trick of cycling the control lever to clear air pockets. Best for owners troubleshooting a no-lift loader before paying for a pump repair.
Shop Rag Sam presents practical, anecdote-driven repair advice and also sells service manuals, so expect some promotion of that product alongside the tips.
It could be low or contaminated hydraulic fluid, a clogged filter, air in the suction line, or a stuck or misadjusted relief valve bleeding off pressure.
Check the hydraulic fluid level and condition first by pulling the transmission dipstick, since the hydraulic system shares fluid with the transmission.
Around 2,400 PSI, though you should get the exact spec and adjustment procedure from the service manual rather than guessing.
Cycle the loader control lever back and forth about 20 times with the engine running to burp out air pockets in the valve body.