Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY walkthrough of replacing a leaking oil pan gasket on a John Deere 5510 with 8,800 hours. The owner shows the real difficulty of the job: draining antifreeze lines, disconnecting the hydraulic return line, removing the front wheel drive shaft, and jacking up and lowering the front axle to clear the oil pan. Useful for owners tackling this specific repair themselves who want real troubleshooting tricks, not a polished tutorial.
Posted by an owner-operator documenting their own repair work on their tractor, sharing hard-won tips rather than a professional or dealership perspective.
Drain antifreeze lines crossing the pan, disconnect the hydraulic return line, remove the front wheel drive shaft, then jack up the frame and lower the front axle about an inch on each side to clear the oil pump.
Use a plastic spatula, not metal or a chisel, to avoid scratching the engine block which could cause leaking.
The owner recommends ordering a new gasket, about 40 dollars from John Deere, since the gasket fits around holes and a sealant tube is not recommended.
Four bolts on each side, with a heavy duty 29 millimeter head that required heating and an impact driver to remove.
