Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow how-to, not a review: Jeremy walks through attaching and detaching a claw grapple on a Yanmar SA series tractor, step by step, positioning the connecting bar, seating the hooks, routing hoses to the third function valve, purging air, and relieving hydraulic pressure before disconnecting. No pricing, performance, or general tractor impressions. Best for SA series owners who already have a grapple and need the exact mounting procedure.
Posted by the official YANMAR//Academy channel, so it's manufacturer-produced instructional content rather than an independent owner's take.
Position the grapple on level ground, angle the connecting bar forward, line it up with the hooks, raise the loader, then tilt the grapple backward and install both pins.
Clean the third function valve couplers to keep out dust and dirt, then route and connect the flexible hoses before raising the grapple.
Raise the grapple, activate the third function valve with the loader joystick button, and move the joystick side to side to open and close the grapple while purging air.
Lower the parking stand, remove the pins and clips, lower the grapple level and free of the hooks, then turn off the tractor and relieve hydraulic pressure in accessory mode before disconnecting hoses.