Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on maintenance walkthrough focused specifically on the 4710's hydraulic oil suction screen: where it's located (opposite the suction tube, unlike most other John Deeres), how to drain the fluid, remove the two-bolt cap, pull and clean the screen, and refill to the correct dipstick level. It also explains symptoms of a clogged screen like surging or slow hydraulics. Best for owners troubleshooting hydraulic issues or doing routine fluid maintenance themselves.
Posted by the Darren Mas channel, presented as a practical, experience-based maintenance demonstration rather than a dealer or sales pitch.
It is on the left side of the machine, opposite the suction tube side, unlike most other John Deeres where you must pull the tube assembly off.
Surging, air in the hydraulics, or slow hydraulics. These signs mean the screen may be plugged and needs inspection and cleaning.
Drain the fluid, remove the two bolts and cap, slide the screen out, then scrub it with a soft brush, hot water, and dish soap before reinstalling.
About five gallons, give or take a gallon, then check the dipstick in the back and fill to the middle of the dipstick.
