Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-operator on a 22-hp Mahindra walks through tiller speed versus tilling depth, then demonstrates actual passes in first gear (0.6 mph, 6-8 inches deep) and second gear (~1 mph, ~3 inches deep), skipping third because it bogs the tractor. He also shows dismounting the tiller without leaving the seat. Useful for small-tractor owners deciding whether their machine has the low-range gearing a tiller really needs.
In first gear, about 0.6 miles per hour, the tiller goes every bit of six to eight inches deep, like a lettuce bed.
No, third gear bogs the tractor down. You could maybe do one or two inches with multiple passes, but it would be really hard.
No, you don't have to get off your tractor to offload the tiller, though the quick hitch's short shaft makes it hard to reach.
Second gear runs almost one mile per hour and tills about three inches deep, less than the six to eight inches from first gear.