Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Focused entirely on protecting the Kubota BX Swift-tach hydraulic coupler, this video covers two specific tips: always relieving hydraulic pressure before connecting or disconnecting the loader, and using short pieces of half-inch PEX pipe to keep the dust caps clean between loader swaps. The creator walks through a real spill he caused by rushing, which grounds the advice in practical experience. Best for BX owners who frequently swap the loader for a mid-mount mower.
Always turn the machine off and move the loader arm to relieve hydraulic pressure before connecting or disconnecting, so you are not forcing the lever down under high pressure.
The lever was hard to press down, and once the tractor fired up it sprayed hydraulic fluid all over the barn floor because pressure had not been relieved first.
Slide short pieces of half-inch PEX pipe (or CPVC) inside the dust caps before popping them onto the connections, keeping them clean while the loader is off.
The video author prefers not to, since the quick disconnect design lets you remove the loader fast without getting off the tractor to release four separate connections.