Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A hands-on fabrication video, not a tractor review. The owner walks through cutting, extending, and re-welding a Land Pride York rake's lower link tubes to convert from Category 1 to Category 2 spacing (25" inside to 32") to match his M6040's quick hitch, then covers pin and bushing adapter sizing and demonstrates a homemade tapered reamer for enlarging holes. Best suited for DIY owners comfortable with welding who face the same Cat 1/Cat 2 mismatch problem.
Cut out the original end tubing, weld in box tubing extensions to go from 25 inches to 32 inches inside spacing, then ream the holes to fit Category 2 pins.
Category 1 runs 25 inches between pins inside to inside, while Category 2 needs 32 inches, a 7 inch difference split between both sides.
Yes, Category 2 pin nuts are almost a half inch thick, so you shrink the outside measurement by taking a half inch off each side for clearance.
A homemade tapered reamer with a nut welded on the end, run with an impact and socket, enlarges holes smoothly without binding like a drill.