Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A hands-on owner account of cutting a Kubota pin-on bucket's factory mounts and welding on a purchased SSQA adapter plate, shown in real time, with honest mid-project plan changes. Covers plasma-cutting challenges, revised approach when removal stalls, welding the plate on, and a frank cost-and-time verdict (10+ hours, ~$200 in parts). Most useful as a candid 'is this worth attempting' reality check for anyone weighing the same DIY conversion.
The owner spent over ten hours total, including hours of cutting, prying, and welding, calling it a lot of work.
The adapter plate cost around two hundred dollars, plus the time and tools needed to cut off the old mounts and weld it on.
The owner says no, rating it four out of ten, and suggests buying a used or quick-attach bucket instead if you lack a welder and plasma cutter.
You need a plasma cutter or torches and a welder, plus a lot of time, since removing the old factory mounts is very difficult.