Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-filmed repair account showing how stripped three-point hitch mounting bolts get fixed after backhoe abuse on a Kubota L3410. The creator walks through retapping the holes with a 12mm 1.75 tap and die, swapping in longer 1.5-inch bolts, and dealing with a twisted frame section that required partial seat removal. Practical but rough around the edges, most useful to owners facing the same stripped-bolt failure.
The original bolts were only one inch long and threaded in about a quarter of the way, even though the holes were about three-quarters deep, and heavy backhoe use digging roots put too much stress on them.
A 12 millimeter 1.75 tap and die was used to retap all the stripped holes before installing new, longer bolts.
The owner said the repair took about four to five hours, with most of that time spent finding the right bolts at a hardware store.