Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A first-time owner documents unboxing, assembly, and initial use of an LS-branded Sicma MRT 3072 rototiller on a homestead pasture. Most of the runtime covers the hands-on hookup process, PTO shaft installation, slip-clutch basics, top-link pin improvisation, and a Pat's quick-hitch complication, plus a few tilling passes and a brief post-rain soil check. Best for new tiller owners who want a frank, unscripted look at first-time setup.
Grease the shaft first so it attaches easier and keeps dirt out, then push it onto the gearbox shaft and tighten the bolts, aligning the screw with the slot on the shaft.
It is preset from the factory and not meant to be adjusted, but if it spins too easily you can tighten the nuts. It is better to have it too loose than too tight.
Yes, it adds about three inches of length, which can throw off the PTO shaft fit and may require removing the quick hitch pads.
Max depth was about seven to eight inches. After two days of rain, clumps were small and feet sank in about an inch after tilling each area two to three times.