Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A hands-on walkthrough of the specific modifications needed to mount a King Kutter XB tiller onto a John Deere iMatch quick hitch, problems most videos skip entirely. The owner shows two real fabrication fixes: replacing the top-link spacer with scrap square tube and extending the lower-link pins using 7/8-inch ID steel tubing cut to size. Useful for anyone attempting the same iMatch conversion with a subcompact-sized implement.
Replace the top-link spacer with scrap square tube for clearance, then extend the lower-link pins using 7/8 inch ID steel tubing cut to size for the wider Category 3 hitch.
The grab hook on the iMatch is too wide, so the original retaining pin and ramp-shaped round stock must be removed and replaced with a square tube spacer for clearance.
No, the goal was to avoid permanent modifications so the tiller stays factory stock, keeping it sellable later, even though welding may have been easier.