Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is an owner's rambling winter-prep session, not a focused review: front and rear tire chains going on a Kioti, a snowblower shoe adjustment, and a DIY plow-mount reinforcement using angle iron and square tube, welded up by a friend. It's casual and unpolished, jumping between tasks including a Harbor Freight quick-hitch grease fitting mod. Best for owners curious about real-world chain and plow-mount fixes, not spec or performance seekers.
Weld angle iron and square tube to the bottom and back of the mount, then run chain through the tube and over the bucket to draw it in tight.
The shoes were worn down to the edge, so they were adjusted up and down to stop it from sucking gravel out of the driveway while still throwing snow.
The owner used tensioners that were difficult to work with, then switched to a binder after trying busted tie-down straps on the rear chains.