Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Focused entirely on correct brush hog setup before mowing, not a product review or general overview. The owner walks through leveling the cutter left-to-right with a tape measure, setting the front-low/rear-high pitch using scrap lumber as gauges, and adjusting the rear skid wheel to carry proper weight. Real hardware work is shown on a 20-year-old mower. Best for first-time brush hog users or anyone getting inconsistent cuts.
Posted by the TexasPrepper2 channel, which appears to be an owner-operator sharing hands-on experience from their own rural property.
Raise a tape measure off the ground and measure the front on both sides, making sure both sides are the same distance off the ground before adjusting.
The front should be an inch and a half to two inches lower than the back so cut material can clear out instead of getting mulched up.
So most of the weight rests on the wheel, helping the mower ride smoother and float better over obstacles like mounds instead of banging around.
A cordless impact wrench, which the owner says works great and gets used all the time for backing out tension bolts.
