Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This video follows one owner's iterative fix for a PTO snow blower that leaves a gap at the cutting edge. He fabricates and mounts a rubber strip from a $30 stable mat, discovers the stainless bolts bent under load, then upgrades to larger fasteners spaced every five inches. Real-conditions feedback is included, but actual blowing footage is brief. Best for owners troubleshooting the same cutting-edge scraping issue.
Cut strips from a half-inch thick rubber stable mat and mount them to the cutting edge with stainless screws, countersunk underneath, so it lies flat and scrubs the snow off the asphalt.
The original stainless bolts were too small (around number seven thirty-seconds) and stainless steel does not have the same tensile strength as regular steel, so ice chunks caused them to bend.
The owner upgraded to larger bolts and changed the spacing pattern to every five inches instead of every ten inches for a more secure mount.