Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A Q&A-style troubleshooting session with a guest (Ken) walking through the most common compact-tractor loader hydraulic problems: couplers that seem connected but aren't, relieving line pressure before disconnecting, leaking O-rings, and how to locate and tighten a dripping fitting without panicking. Practical and specific, with real product references (WD-40 for cleaning, UV dye for leak detection). Best for new compact-tractor owners baffled by a loader that suddenly won't lift or won't disconnect.
About 90 percent of the time a coupler has become slightly uncoupled from hitting a stick or stepping on it. Take all four couplers apart, clean with WD-40, check for debris, and recouple them.
There is pressure trapped in the lines. Turn the tractor off and wiggle the joystick in all four directions to send pressure back to the tank, relieving the connection.
Turn the key on but do not start the tractor, then operate the third function so the relay clicks. The valve needs power to cycle and release trapped pressure.
The O-ring that seals the connection inside the female coupler is likely nicked or scarred from dirt or debris. Pull it out with an O-ring pick and replace it.