Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A farm-vlog tutorial focused on hooking up and leveling a Woods BB72x brush cutter to a John Deere 5065's three-point hitch. It walks through lift arms, PTO shaft safety, using a spud wrench, and leveling the deck front-to-back and side-to-side. The pacing is loose, a Cat track loader arrival interrupts the lesson mid-way, but the leveling steps near the end are practical. Best for first-timers learning proper brush hog setup.
Line up the lift arm inside the hitch section, lift and move it over, using a spud wrench to help align the pin hole, then connect the PTO shaft with the tractor shut off.
Lower it until it just touches the ground, check height on both sides so they match, then use the three-point raise and lower to set the optimum level position.
Adjust the top link out slightly to allow more flex in the bush hog so the back wheel stays on the ground going over hills.