Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on diagnostic walkthrough for John Deere E-Hydro/electronic controller tractors like the 4210, focused specifically on a no-move fault. It covers reading the onboard diagnostic light codes, backprobing the hydro pedal sensor wire with a needle and multimeter to check voltage ranges, and performing the controller relearn/recalibration procedure on jack stands with all wheels off. Best suited for owners actually troubleshooting a stuck or unresponsive hydro system, not casual shoppers.
Posted by Darren Mas, who presents as an experienced hands-on operator/technician working through an actual repair on his own machine.
The controller cannot get a proper signal from a sensor, like the hydro pedal sensor, or a variable sensor reading is out of range, so it will not move as a safety precaution.
Backprobe the purple wire with a sewing needle and multimeter; neutral should read under 1 volt (about 0.7), rising to about 4.1 volts at full pedal.
Take the fuse out, put it in the relearn slot, and turn the key on. The diagnostic light will glow and stay on, confirming relearn mode.
No, the relearn sequence requires running at full throttle and pressing hydro pedals, so the machine should be on jack stands with all wheels off.