Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step how-to for removing the front grille/nose cone on a 2019 John Deere 1025R, done to access wiring for an electrical mod. It covers the full teardown: trim panel screws, ten 10mm bolts (marked with paint pens for reference), the headlight harness clip, dealing with a snowblower mount bracket, and reassembly with lubricant tips. Useful for 1025R owners doing their own maintenance or mods on this specific panel.
There are ten 10mm bolts total, marked with white paint pen lines for reference during reassembly.
Take a flathead screwdriver, pop it into the clip a little, then push the clip down to release the harness plug.
The snowblower bracket blocks two corner bolts, so you may need to loosen it or sneak the bolts out with a pry tool and open-end wrench.
Tuck wiring into the plastic, apply light lubricant to the slide rails, tilt the battery, line up posts into holes, then bolt it back down.