Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow how-to on a specific repair: rebuilding the power steering cylinder on a 5056E, where the gland is held by two snap rings rather than threading off like most cylinders the presenter has rebuilt before. He walks through removing hoses and tie rod, popping both snap rings, pulling the gland, and reseating it with new seals, plus a rough cost comparison to buying a replacement cylinder. Best for owners mid-repair on this exact leaking-cylinder problem.
Posted by a mechanic doing the repair as a favor for a friend, not a John Deere specialist, sharing hands-on troubleshooting rather than a scripted tutorial.
Remove the hoses and tie rod, then remove the outer snap ring, push the gland all the way in by lifting the axle and turning the tire, then remove the other snap ring and pull the gland out.
No, unlike most cylinders which unscrew, this gland has no threads and is held in place by two snap rings.
eBay sells the cylinder for around two hundred dollars, while the seal kit for rebuilding is estimated at around a hundred dollars.