Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-operator walkthrough focused on prepping a Land Pride RCR 1248 rotary cutter for use on a Kubota B2601, not a review or demo, but a practical maintenance and setup routine. It covers greasing driveshaft and tail wheel bearings, checking gearbox oil for water contamination, hooking up the PTO shaft safely, and setting cutting angle with a magnetic level. Best for owners who already have this cutter and want real-world setup tips.
Drain a bit of oil and check it is not milky, since water can get in even though the gearbox sits under a cover.
Tilt it slightly toward the front, about a sixteenth to an eighth of an inch down from level, so grass discharges out the back instead of toward the operator.
Bring the tractor down to idle or under half throttle, then turn on the PTO, rather than engaging at high throttle which can slam the drivetrain and break shear pins.