Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow how-to fix for a specific annoyance: a hydraulic coupler that won't reconnect on a 1023E/1025R because residual pressure is trapped in the line. The video shows tapping/pushing the fitting to release trapped pressure until the pin moves and the connector seats. It's short and single-purpose, not a general maintenance overview, useful mainly for owners currently stuck with a hydraulic line that won't insert.
Posted by the Johnny's Tips and Tricks channel, an owner sharing a quick practical fix rather than a professional or dealer resource.
One of the lines still has residual pressure trapped in it because the pressure wasn't fully released when it was first disconnected, so the pin won't move.
Tap on the fitting to force trapped pressure out, repeating as needed until fluid sprays and the pin starts moving, then the connector will go in.
Turn off the engine and cycle the controls around to relieve pressure before disconnecting, which normally lets the lines go on and off easily.
| John Deere 1025R | John Deere 1023E | |
|---|---|---|
| PTO horsepower | 18 hp | 16 hp |
| Loader lift capacity | Not Published | 120R: 1,823 lbf (at pivot point) |
| 3-point lift capacity | 1,177 lb | 1,177 lb |
| Hydraulic flow | 3.5 gpm | 3.5 gpm |
