Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This video focuses specifically on first-time bush hog setup on a Kubota B2601, centering almost entirely on diagnosing and correcting a PTO driveshaft that's too long, including why it matters, how to measure, and the actual cutting and reassembly with an angle grinder. It's a practical, step-by-step owner walkthrough rather than a buying guide, most useful to compact-tractor owners tackling their first bush hog installation.
Raise and lower the mower without the PTO connected and watch the shaft. If it closes in on the PTO at full height with little room to expand or contract, it is too long.
The shaft was only about an inch too long, but three inches were cut off each side to give the mower extra flexibility to rise and compress the shaft further.
Because the mower floats on the three-point, raising the back end pushes the shaft toward the PTO. Without clearance, this can destroy the PTO gearbox.
The outer shaft is the one with the label on it, making it easy to identify when reassembling the two halves.