Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This video is a real-world diagnostic walkthrough for a Kubota L48 that wouldn't start, caused by a faulty magnetic stop solenoid. The owner locates the part, explains how to test it (pulling the coil, checking for 12 volts across the connector pins), and covers related suspects like the seat, clutch, and transmission safety switches. It's a focused troubleshooting guide, best suited for L48 owners facing a no-start or intermittent-start issue.
Posted by the Jeffrey Cantrell channel, an owner sharing a hands-on repair experience from his own tractor and work site.
It can be caused by a faulty magnetic stop solenoid, or by bad seat, clutch, transmission, or PTO safety switches preventing the solenoid coil from pulling in.
Disconnect the plug's two connection pins, turn the key on, and test for 12 volts with a grounded voltage meter. No voltage means power isn't reaching the solenoid.
Remove the two 12-millimeter nuts holding the coil in and pull it out. If the engine then runs, the solenoid is the problem.
Unscrew the manual stop switch to remove the magnetic stop solenoid, which lets the tractor start immediately, though some oil will leak out.