Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This one skips sales talk entirely and walks through a Kubota M5 loader's owner's manual before physically detaching the loader from the tractor. It covers grease fitting locations, the high-lift versus low-lift pin positions, the self-leveling valve adjustment, the control lever's lock position, and then the actual removal steps: parking stands, releasing hydraulic pressure, capping hoses, and backing the tractor away. Best for owners doing hands-on loader maintenance or attachment swaps.
Appears to be an owner or operator walking through manual-based procedures on their own equipment, not a dealer promotion.
Set parking stands, lower and tilt the bucket slightly, remove mounting pins, shut off tractor, release hydraulic pressure, cap the hoses with dust plugs, then back the tractor away.
High lift position gives the most reach out of the loader, while the low lift position in the bottom holes gives more power. Pins on both sides must match or the loader gets damaged.
No, it is factory adjusted to work in the high lift position. In low lift it will be off unless adjusted using the manual's procedure, or it can be turned off.
It locks the control handle so it does not move. It does not prevent hydraulic leaks but prevents accidental bumping of the handle and the loader dropping.
