Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step aftermarket install guide for the Badlands Armor cab screen kit on Kubota M series/M5 tractors, not a review or overview of the tractor itself. It walks through mounting the rear door screen, left and right wings, and lower screen, covering drilling, hole placement, hardware, and cylinder swaps in hands-on detail. Useful mainly for owners who've already bought this cab guard kit and need installation help.
Posted by CL2 Designs & Manufacturing LLC, the maker of the cab kit, so it's an instructional install video from the product's own manufacturer rather than an independent review.
Remove the plastic bracket holdback, replace it with the metal plate provided, install plungers on the outside, and secure with screws and a quarter inch nut on the back side using the lower holes.
Use a small screwdriver to pop out the C-keeper holding the old cylinder, then pop the new, stronger cylinder into place.
Remove the mechanism holding the glass to the hinge, keep the rubber washers, install female holdbacks with the provided hardware, then line up the top corner first and pop the bottom one into place.
Slide out the old panel, hold the new one against the bottom of the roof frame centered with tabs touching, pre-drill four holes just under three sixteenths, and fasten without overtightening.
