Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a short owner-made demo, not a buying guide. The creator shows aftermarket LED work lights installed on a Boomer 40's front door completely wiping out AM/FM radio reception, while the stock rear halogen lights cause no interference. He explains the cause (unfiltered switch-mode power supplies inside cheap LED housings) and warns it could also affect sensor readouts. Useful mainly for Boomer 40 owners troubleshooting electrical noise, not general shoppers.
Posted by the w8bya channel, an owner sharing a hands-on troubleshooting observation from their own tractor rather than a dealer or reviewer.
The cheap LED housings contain unfiltered switch-mode power supplies that dump radio frequency interference onto the 12 volt lines feeding the tractor, including the radio.
No, turning on the rear stock halogen lights has no effect on radio reception, only the front aftermarket LED lights cause the interference.
Yes, the interference can affect the instrumentation system and the readout of some of the sensors inside the tractor.
Adding a filter network of capacitors and inductors inside the LED housing would filter the interference, costing manufacturers only four or five dollars.